Stainless Steel Elevator Expansion Anchor Bolt With Hex Nut For Water Heaters
Product Description:
The principle of the expansion screw fixing: The expansion screw is
fixed by using the rake-shaped slope to promote the expansion of
the friction to produce a binding force, to achieve a fixed effect.
Screws are threaded at one end and vertebral at one end. The
outside of the bread is made of steel. There are several incisions
in the iron cylinder. Put them together into a hole in the wall.
Then lock the nut. Pull the nut outwards and pull the vertebra into
the steel cylinder. The cylinder is stretched open, so it is
tightly fixed to the wall. It is generally used for the fastening
of fences, awnings, air conditioners, etc. on cement, bricks and
other materials. However, its fixation is not very reliable. If the
load has a large vibration, loosening may occur, so it is not
recommended for installing ceiling fans. The principle of the
expansion bolt is to hit the expansion bolt into the hole in the
floor or wall, tighten the nut on the expansion bolt with a wrench,
the bolt goes outside, and the outer metal sleeve does not move, so
the big head under the bolt puts it The metal sleeve expands open
so that it fills the entire hole. At this point, the expansion bolt
cannot be extracted.
Product Parameters:
| specification |
M6 |
M8 |
M10 |
M12 |
M14 |
M16 |
M18 |
M20 |
length |
50
60
65
80
100 |
60
70
80
90
100
110
120 |
70
80
90
95
100
110
120
130
150 |
80
90
100
110
120
130
150
180
200 |
100
125
150 |
100
120
125
145
150
180
200
250
300 |
150
180
200
250
300 |
150
180
200
250
300 |
Expansion Bolt Specifications Indicate:
Bolt Size M14 indicates a metric thread of 14mm thread. M stands
for "metric, metric" thread. The complete thread mark is made up
of: Thread Feature Code + Size Code + Tolerance Band Code + and
Other Information + Standard Code(Such as: on the domestic screws
plus GB code)
1, the thread characteristics of the code letter "M"
2, size code
Single-thread size code for the "nominal diameter × torque." Coarse thread can be omitted marked with its screw moment. Multi-thread size code for the "nominal diameter × Ph lead
P-torque."
3, the tolerance zone code by the number of letters (the upper
thread of the female thread, the lower case of the male thread),
such as 7H, 6g, etc., should be particularly pointed out that 7H,
6g and so on behalf of thread tolerances, and H7, g6 represent
cylinder toleranceCode
4, the provisions of the screw length of the short (with S), in
(with N), long (L) three. Under normal circumstances, do not mark the screw thread length,
the thread tolerance band to determine the length of the medium
length (N). If necessary, add a spin length code S or L, eg "M20-5g6g-L". Special needs, you can indicate the value of the spin-on length,
such as "M20-5g6g-30".
5, left-hand thread should be marked with "LH" after the length of
the screw. Sewing length code and spin code with "-" separated, right-hand
thread omitted Note.
6, mark example:
M 16-5g6g said ordinary coarse thread, the nominal diameter of 16,
right-hand, thread tolerance with a diameter of 5g, diameter 6g,
screw length according to the medium length to consider.
M16 × 1 LH-6G said fine teeth ordinary thread, nominal diameter 16,
pitch 1, left-hand, thread tolerance band diameter, diameter are
6G, screw length according to medium length consideration.
